The call
A hotel kitchen in Van Nuys started the descaling program on its Rational SelfCookingCenter. Partway through, steam started coming out of the unit and the oven stopped working. They called us the same day.
What we found
Once we opened it up, the picture was clear. Steam and water were blowing out from under the heating element gasket on the steam generator. The water had reached the electronics and the heat had melted the pre-fill container at the back of the generator. The drain pump was also dead, the heating element had burned out, and the flowmeter had already been leaking before this happened.
One failure had turned into five. That is typical: a leak on a steam generator rarely stays a leak.
The repair
We assessed everything on the first visit and ordered all the parts at once, so the kitchen would not pay for repeat diagnostics. Most of the parts arrived the next day, and on the third day after the call we were back installing them. The rest had a shipping delay, and we finished the job five days after the call.
We replaced the heating element and its gasket, the pre-fill container, the drain pump and the flowmeter, dealt with the water-damaged electronics, and ran the oven through steam, cleaning and full test cycles.
The result
The oven is back in daily service after a failure that many would have called a replacement.
What we recommend
Descale strictly by the manufacturer's schedule, and never skip it
When descaling is skipped, scale builds up inside the generator tank, clogs the water lines and starts taking out other components along the way.
Install a water filtration system
A combi in Southern California should run on treated, softened water. It is the single cheapest way to protect the steam generator. Our technicians install and service water filtration systems for combi ovens.
Do not ignore small problems
A drip under the oven or a part that "works a bit strange" looks minor, but it ends up expensive. One failed or misbehaving component drags others down with it, exactly as it did here, where a leaking flowmeter and a tired gasket ended in five failed parts.
Catching these early is what keeps a combi running correctly for a long time.
See also steam generator repair and descaling.